FUJITSU MPF3XXXAT User Manual
Page 99
C141-E099-01EN
5 - 34
Table 5.5
Information to be read by IDENTIFY DEVICE command (5 of 5)
*20 Word 93: CBLID– detection results
Hardware reset result. The contents of bits 12-0 of this word shall change only during the
execution of a hardware reset.
Bit 15:
Shall be cleared to zero
Bit 14:
Shall be set to one
Bit 13:
1=Device detected CBLID– above V
IH
0=Device detected CBLID– below V
IL
Bit 12-8:
Device 1 hardware reset result. Device 0 shall clear these bits to zero
Device 1 shall set these bits as follows:
Bit 12:
Reserved
Bit 11:
0=Device 1 did not assert PDIAG–
1=Device 1 asserted PDIAG–
Bit 10-9: These bits indicate how Device 1 determined the device number:
00=Reserved
01=a jumper was used
10=the CSEL signal was used
11=some other method was used or the method is unknown
Bit 8:
Shall be set to one
Bit 7-0:
Device 0 hardware reset result. Device 1 shall clear these bits to zero
Device 0 shall set these bits as follows:
Bit 7:
Reserved
Bit 6:
0=Device 0 does not respond when Device 1 is selected
1=Device 0 responds when Device 1 is selected.
Bit 5:
0=Device 0 did not detect the assertion of DASP–
1=Device 0 detected the assertion of DASP–
Bit 4:
0=Device 0 did not detect the assertion of PDIAG–
1=Device 0 detected the assertion of PDIAG–
Bit 3:
0=Device 0 failed diagnostics
1=Device 0 passed diagnostics
Bit 2-1:
These bits indicate how Device 0 determined the device number:
00=Reserved
01=a jumper was used
10=the CSEL signal was used
11=some other method was used or the method is unknown
Bit 0:
Shall be set to one
*21 Word 128: Security status
Bit 15-9:
Reserved
Bit 8:
Security level 0=High, 1=Maximum
Bit 7-6:
Reserved
Bit 5:
1=Enhanced security erase supported
Bit 4:
1=Security count expired
Bit 3:
1=Security frozen
Bit 2:
1=Security locked
Bit 1:
1=Security enabled
Bit 0:
1=Security supported