Fluke DDS Function Generator 271 - Manual (Page 20)

271
Getting Started Manual
TRIG/SWEEP OUT
The TRIG/SWEEP output
socket provides both trigger
and marker signals,
depending on the
instrument's mode of
operation.
shx0016f.gif
Its primary use is for triggering an oscilloscope or other
recording device, but it can also provide z-axis bright-up
markers during sweep and frequency-hopping modes.
RS232 and GPIB Interface Connectors
These sockets are for
controlling the instrument
remotely, using a PC or
other controller device.
Remote control is beyond
the scope of this Getting
Started Manual
, but is
covered in detail in chapter
16 of the Users Manual.
shx0017f.gif
10