Fostex D824 - Manual (Page 6)

6
D824/D1624 Quick Operation Guide
Preparation for the current drive
Removable case Hard disk unit
Dust cover
Insulation seals
Lock-unlock key
Fixing screws
This recorder has a slot for an optional hard disk. First you need to install a hard disk into the
removable case included in this recorder package before you install it into the slot.
The following instructions assume that you have already purchased an E-IDE hard disk unit.
Prepare the following items for hard disk installation:
Be sure to turn off the power to the recorder (or remove the power cable from the AC outlet) before
installing a hard disk.
First, you need to disassemble the removable case included in the package so that you can install a hard
disk into it.
Installing a hard disk in a removable case
Disassembling the removable case
1 .Apply your thumb to the edge of the case on the connector side as shown in the figure, and slightly pull the cover in the
direction of the arrow.
2 .Apply your thumbs to the side of the case and open the cover. In the same manner, open the cover on the other side.
(Caution: Be careful not to pinch your fingers.)
• A hard disk is a high-precision device. Do not apply any impact to the disk when and after you install it in
the case. Do not leave the disk near a device that generates a strong magnetic field. Choose a level and stable
surface for installation. Be careful not to injure yourself.
Fostex is not liable for any malfunction or damage to the hard disk caused by mishandling.
• You need to set the DIP (Jumper) switch on the hard disk to “MASTER” before you install it into the removable
case. If the switch is set to “SLAVE,” the hard disk will not function correctly.
Refer to the instruction manual that came with your hard disk for more information on the DIP (Jumper)
switch setting.