Undo and redo recording (single undo/redo), Hints, Undo/redo key) – Fostex D824 User Manual
Page 18: Cautions for the multiple undo function
18
D824/D1624 Quick Operation Guide
Everybody makes mistakes. If you make a mistake in recording, you can restore and re-do the data that
existed before the mistake occurred. These functions are called “Undo” and “Redo,” and are executed by
the UNDO/REDO key on the control panel.
The Undo function enables you to cancel the latest recording or edit and restore the previous state.
Using the Redo function after using the Undo function enables you to cancel the Uno operation and
restore the latest recording or edit. These functions have some limitations as described in the
below.
As described earlier in "Formatting a new disk", if you format the disk with the multiple undo
function ON, "multiple undo" is possible. See "Multiple undo function" in the Reference manual.
You can repeatedly use the Undo/Redo functions until you
perform one of the following operations:
* You make a new recording.
* You perform a new edit (Copy/Paste, Move/Paste, Auto
Punch in/out, Erase, etc.).
* You turn off the power to the recorder.
* You select a different Program.
* You execute the Multiple Undo operation.
1.After making a recording (or playing back a newly
recorded data), press the UNDO/REDO key.
The recorder displays [Undo!], then [COMPLETED !], and
displays the previous Time Base indication.
Undoing the recording will restore the status obtained
before recording.
Before recording
After recording
1, 2
(UNDO/REDO key)
The recorder displays [Redo!], then [COMPLETED !], and
displays the previous Time Base indication.
Performing the Redo operation will cancel the Undo
operation and restore the state obtained after recording.
44.1kHz
COMPLETED!
42
∞
_
OL
0
8
7
6
5
4
3
2
1
30
24
18
12
9
6
3
16
15
14
13
12
11
10
9
42
∞
_
OL
0
8
7
6
5
4
3
2
1
30
24
18
12
9
6
3
16
15
14
13
12
11
10
9
The single undo/redo function executes undo/redo
operation only against the latest take.
The "multiple undo function" can execute undo
against all takes after the current disk had been
formatted. When the multiple undo function is
set to ON, the recorder stores all takes automati-
cally and can recall the desired take (undo) if nec-
essary.
Undo and redo recording (single undo/redo)
• Multiple undo is possible only when the current
disk is formatted with the "Multiple undo function"
ON.
• A disk formatted with the multiple undo function
ON has more information stored on it more than a
disk formatted with the multiple undo function OFF.
• With the single undo/redo function described
above, the data you undo will be erased when the
next recording is done. Therefore, once you execute
a single undo, the undone take cannot be restored
even if you execute multiple undo later.
* Refer to the Reference manual for details.
2.To cancel the undo operation, press the UNDO/
REDO key again.
Recorded area
Undo
Redo