FujiFilm A330 - Manual (Page 26)

51
Settings
4
TIME DIFFERENCE (TIME DIFFERENCE SETTING)
Press “d” or “c” to change between “™ HOME”
and “£ LOCAL”.
To set the time difference, select “£ LOCAL”.
™ HOME : Your home time zone
£ LOCAL : Your destination time zone
1
1 Press “a” or “b” to select “TIME DIFFERENCE”.
2 Press “c”. 2
0 1 0 2
1 Press “d” or “c” to select ±, hour and minute.
2 Press “a” or “b” to correct the setting.
h Available time settings
-23:45 to +23:45 (in 15 minutes increments)
3
0 1 0 2
Continued 50
SET-UP
When the camera is in Sleep mode, pressing the
Shutter button down halfway wakes the camera up
so that it is ready to take pictures. This is useful
since the camera can be ready to take pictures
almost instantly.
● ! Pressing any other button as well as the Shutter button
wakes the camera up.
When this function is enabled, the screen temporarily
turns off (Sleep mode) and the viewfinder lamp
(green) blinks at 1 second intervals to save power if
the camera is not used for 30 seconds. If the camera
remains unused for an additional interval (2 minutes
or 5 minutes), it is turned off. Use this function when
you want to get the maximum possible running time
from your batteries.
● ! The Power save setting is disabled during automatic
playback, during rechargeable battery discharging and when
a USB connection is being used.
POWER SAVE SETTING
The Sleep function does not operate in SET-UP or Playback mode, but the camera will turn off if it
is left unused for a set some time (2 minutes or 5 minutes).
◆
To restore power to the camera
◆
To restore power to the camera to take pictures,
briefly close and then re-open the lens cover
completely so that it makes two successive clicks
and will not move further. To play back images, close
the lens cover until it stops and then hold down the
“Playback” button for approx. 1 second.
OFF ON
FORMAT
Formatting erases all the frames (files).
Initialize the xD-Picture Card for use in the
camera.
Back up important frames (files) onto your computer
or another media.
1 Press “d” or “c” to select “OK”.
2 Pressing the “MENU/OK” button erases all the
frames (files) and initializes the xD-Picture
Card.
Formatting erases protected files also.
● ! If “ å ”, “ ˚ ”, “ ƒ ” or
“
©
” appears, see P.78 for information
before formatting the xD-Picture Card.
This function sets a time difference relative to the date and time currently set. When this setting is
enabled, the specified time difference is applied when pictures are taken.
Use this function when traveling to destinations in different time zones.