FujiFilm 1400 - Manual (Page 7)

13
1
12
SELECTING THE POWER SUPPLY
1 Using Batteries
Use 4 AA-size alkaline, Ni-MH or Ni-Cd batteries.
Do not use different types of batteries together.
■ Number of available shots (with fully charged batteries)
The table below provides a guide to the number of shots that
can be taken at normal temperature with 50% flash use.
Note that these figures may vary depending on the camera’s
ambient temperature and the level of battery charge.
Slide the battery cover in the direction of the
arrow and open the cover.
● ! Do not use new and used batteries together.
● ! Always switch the camera off when replacing the
batteries. If the camera is left on, the camera
settings may revert to the factory default settings.
● ! Install replacement batteries within 5 minutes, since
the camera settings are only retained for 5 minutes
once the batteries are removed.
● ! The Quick Battery Charger (sold separately) is needed
to recharge AA-size Ni-MH or Ni-Cd batteries (
➡ P.71).
➀
Install the batteries with the correct polarity as
shown.
➁ Close the battery cover as indicated by the
arrow.
2 Using the AC Power Adapter
To shoot or play back images without depleting
the battery charge, use the special AC Power
Adapter AC-5V (sold separately).
Check that the camera is switched off and then
plug the AC power adapter connector into the
“DC IN 5V socket” on the camera. Then plug the
AC power adapter into the power outlet.
● ! You cannot charge the batteries by connecting the
AC power adapter.
● ! The shapes of the plug and socket-outlet depends
on the country of use.
● ! Using AC power adapters other than the AC-5V
could damage the camera.
● ! See P.75 for more information on the AC power adapter.
DC IN 5V socket
◆
Important Battery Information
◆
● Because different brands of alkaline batteries have
different capacities, the life of some batteries (the length
of time for which they can be used) may be considerably
shorter than that of the alkaline batteries supplied with
this camera.
● It is a characteristic of alkaline batteries in particular that
the life of the battery is shorter at low temperatures
(+10°C or below).
● Do not use lithium or manganese batteries in your
FinePix1400 ZOOM because the heat generated by the
batteries could damage the camera.
With LCD monitor
OFF
With LCD monitor
ON
Battery type
Ni-MH battery
HR-3UF
Alkaline batteries
Ni-Cd battery
KR-3UF
Approx.180 frames ✽
Approx.180 frames
Approx.120 frames ✽
Approx.450 frames ✽
Approx.450 frames
Approx.350 frames ✽
➀
➁
◆
When opening and closing the battery cover
◆
● Do not use excessive force on the battery
cover.
● Take care not to drop the batteries when you
open or close the battery cover.
✽ With fully charged battery