Furuno FA-100 - Manual (Page 35)

29
20. Press [4] key to display the SET LAN (IP ADRS) window.
[SET LAN (IP ADRS)]
IP ADDRESS:
000-000-000-000
SUB NET MASK:
000-000-000-000
PORT NO. 10000
SET LAN (IP ADDR) window
21. If the FA-100 is connected to a network, enter IP address, sub net mask and
port number with the numeric keys and the [NEXT] key.
22. Press the [ENT] key and then the [MENU] key to return to the SYSTEM
SETTINGS sub-menu.
23. Press the [4] key to display the SET OTHER I/O window.
[SET OTHER I/O]
AD-10: DSBL
ROT : 01 SEC
+ -
SET OTHER I/O window
24. Select or set other I/O as follows.
1) AD-10: Select ENBL to use AD-10 format gyrocompass signal.
2) ROT: Set smoothing time (1 to 10 seconds) of the ship’s rate of turn if you are
using a ROT meter. This time is used to smooth the variations of data from the
AD-100 for calculation of ROT.
3) Press the [ENT] key to register setting. The display returns to the SYSTEM
SETTINGS sub-menu.
25. Press the [MENU] key. The following confirmation window appears.
SAVE ?
YES
NO
CANCEL
SAVE confirmation window
26. Select YES and press the [ENT] key. The main menu appears.