FUJITSU LIFEBOOK C6577 - Manual (Page 59)

49
M e m o r y U p g r a d e M o d u l e
Memory Upgrade
Module
Your Fujitsu LifeBook comes with 64MB or 128MB high
speed Synchronous Dynamic RAM (SDRAM) factory
installed. To increase your LifeBook’s memory capacity,
you may install an additional memory upgrade module.
The memory upgrade must be a dual-in-line (DIMM)
SDRAM module.
INSTALLING A MEMORY UPGRADE
MODULE
To install a memory upgrade module follow these steps:
1. Turn off power to your LifeBook using the power
switch, and remove any power adapter (AC or
auto/airline).
2. Turn your LifeBook face down on a clean work
surface.
3. Using a Phillips head screwdriver, remove the three
screws securing the RAM Expansion cover. Remove
the cover.
4. Align the connector edge of the memory upgrade
module, chip side up, with the connector slot in the
compartment.
5. Insert the memory upgrade module at a 45 o angle
and press it firmly onto the connector.
6. Press the memory upgrade module down into the
compartment until it locks underneath the retaining
clip. You will hear a click when it is properly in place.
7. Replace the cover over the memory tray and reinstall
the three screws.
Figure 4-7 Adding Memory to the LifeBook
C A U T I O N
Do not remove any screws from the memory upgrade
module compartment, except the ones specifically
shown in the directions for installing and removing
the memory upgrade module.
W A R N I N G
You must turn off power before installing the memory
upgrade module.
C A U T I O N
The memory upgrade module can be severely damaged
by electrostatic discharge (ESD). Be sure you are properly
grounded when handling and installing the module.
P O I N T
The memory upgrade module is not something you
routinely remove from your LifeBook. Once it is
installed, you should leave it in place unless you want
to increase system memory capacity.
(a)
(b)
(c)
& 6HULHV$ERRN 3DJH 7KXUVGD\ -XQH $0