Furuno NAVNET 1823C User Manual

Page 28

1. OPERATIONAL OVERVIEW

1-12

1.5.4

Selecting image source

When more than one network radar or network sounder is connected to the
equipment, you may select an image source for each as shown below. This is
not necessary when only one network radar or network sounder is connected.

1. Press the [DISP] key.
2. Press any soft key to show the following display.

▲

SELECT
SOURCE

EDIT

RETURN

IF THERE IS MORE THAN
ONE NETWORK RADAR OR
ECHO SOUNDER, YOU MAY
SELECT THE IMAGE
SOURCES FOR DISPLAY.

RADAR SOURCE RADAR - - -

SOUNDER SOURCE SOUNDER-

AUX SOURCE

WXFAX - - -

IP ADDRESS

172.031.003.003

HOST NAME RADAR - - -

Select source menu

3. Use the trackball to select RADAR SOURCE, SOUNDER SOURCE or AUX

SOURCE as appropriate, then press the EDIT key.

RADAR SOURCE

SOUNDER SOURCE

Radar source Sounder source

Aux source

ADAR - - -

OUNDER-

AUX SOURCE

XFAX- - - - -

Radar source and sounder source windows

4. Use the trackball and alphanumeric keys to enter source name: Adjust the

trackball to select location and enter character with the alphanumeric keys.

5. Push the [ENTER] knob to set.
6. Press the [DISP] key to finish.
7. Turn the power off and on again.

Note: Source names are determined at installation. For example, the source

names for radars in a two radar system might be “RADAR” and
“RADAR1”.