Troubleshooting – Meridian Audio FDP-DILA3 User Manual
Page 47
Troubleshooting
Symptom
Probable cause
Corrective action
Page
Video imag e is
fuzzy.
Video image is ab-
normally dark or
bright.
Color is poor or un-
stable.
The upper part of
the video image
bows or distorts.
Remote control unit
does not work.
Is focus adjusted correctly?
Is the projector placed too near or too far from
the screen?
Are “Tracking” and “Phase” adjusted correctly?
Is “Brightness” adjusted correctly?
Is picture quality (color, density, etc.) adjusted
correctly?
Is the correct “Decoder” selected?
Are signals (scanning frequency, etc.) from the
connected device appropriate?
Is the PC2 input terminal being used?
While computer signals are input, are sync sig-
nals for composite sync (Cs) or G on sync be-
ing inputted?
Are signals with much jitter or skew distortion
being input from a video deck?
Are batteries installed correctly?
Are batteries exhausted?
Is there an obstructive object between the re-
mote control unit and the remote sensor?
Is the remote control held too far from the sen-
sor?
Adjust focus with the focus ring of the lens.
Set the projector at the correct distance.
Adjust “Tracking” and “Phase” on the menu.
Adjust “Brightness” on the menu.
Adjust picture quality on the menu.
Set the “Decoder” to “AUTO” or the correct
dedicated decoder.
If the problem is not rectified after setting to
“AUTO”, set to forced dedicated mode.
Check if the signal is appropriate (scanning fre-
quency, etc.), and input the appropriate signal.
When the PC2 input terminal is being used,
“PC 2(BNC)” must be selected from the
“Options” menu. Set it correctly according to
the input signal.
Input separate sync signals for vertical sync
(V) and horizontal sync (H) signals.
Input signals with little jitter or skew distortion.
Use a TBC or a device with a built-in TBC.
Match the polarities of batteries correctly, as
shown on the battery cartridge.
Replace with new batteries.
Remove any shielding objects.
Use the remote control unit at a nearer point.
2
5
1
6
3
6
3
6
3
6
3
7
1
8, 19
3
8
1
8, 19
—
—
—
—
—
1
3
1
3
1
7
1
7
• This projector uses a micro computer. External noise may cause it to malfunction. If this happens, unplug from the main power outlet and then
plug on again. (
☞ page 24, 26)
47