FieldServer FS-8700-43 - Manual (Page 9)

FS-8700-43 VESDA Driver Manual Page 9 of 28
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web: www.fieldserver.com
Tel: (408) 262 2299 Fax: (408) 262 2269 Toll Free: (888) 509 1970 email: [email protected]
5.3.2 Driver Related Map Descriptor Parameters
Column Title Function Legal Values
Node_Name Name of Node to fetch data from
One of the Node names specified in
Section 5.1
Data_Type Data type Dig_input, Dig_output, -
Length Length of Map Descriptor 1 to end of data block.
Address Starting address of read block
The start bit number of the data of
interest
Command The command id as given in the notes. 1, 4, 6, 10, 12, 16, 27, 29
Network* The network number 0-255, 0
Zone* The zone number 0-255, 0
Sector* The sector number
1-255 or 0 to read the average smoke
level and highest alarms.
DA_Bit_Name*
Name of Data Array where data is to be
stored in the FieldServer. Used for
commands 10 and 16.
One of the Data Array names specified in
Section 4. Must be of type BIT, -
DA_Bit_Offset*
Starting location in Data Array. Used for
commands 10 and 16 0 to (Data_Array_Length -1) as specified
in Section 4, -
DA_Float_Name*
Name of Data Array where data is to be
stored in the FieldServer. Only used for
command 10.
One of the Data Array names specified in
Section 4. Must be of type FLOAT, -
DA_Float_Offset*
Starting location in Data Array. Only used
for command 10 0 to (Data_Array_Length -1) as specified
in Section 4, -
DA_Byte_Name*
Name of Data Array where data is to be
stored in the FieldServer. Only used for
command 16.
One of the Data Array names specified in
Section 4. Must be of type BYTE, -
DA_Byte_offset*
Starting location in Data Array. Only used
for command 16 0 to (Data_Array_Length -1) as specified
in Section 4, -
DA_Parameters
Name of Data Array where data is to be
stored in the FieldServer. Only used for
command 29.
One of the Data Array names specified in
Section 4. -
DA_Parameters_Offset
Starting location in Data Array. Only used
for command 29 0 to (Data_Array_Length -1) as specified
in Section 4, -