FUJITSU XG1200 - Manual (Page 7)

6 For Safe Use of the XG1200
FCC Class A
CE Marking
CAN/CSA C22.2 No. 60950, UL60950 and EN60950
Under certain conditions, twisted pair cables can become charged with static electricity.
Connecting a statically charged twisted pair cable to a device can cause the device or its LAN
port to operate falsely or to become damaged.
Use a static removal tool to discharge twisted pair cables to ground immediately before con-
necting them to devices.
Note that a discharged twisted pair cable that has been left unconnected for a long time may
become statically charged again.
[Use for the high safety required case]
The XG1200 is designed, developed and manufactured as contemplated for general use,
including without limitation, general office use, personal use, household use, and ordinary
industrial use, but is not designed, developed and manufactured for use in situations with
accompanying fatal risks or dangers that, unless extremely high safety is secured, could lead
directly to death, personal injury, severe physical damage or other loss (hereinafter "High
Safety Required Use"), including without limitation, nuclear reaction control in nuclear facility,
aircraft flight control, air traffic control, mass transport control, medical life support system,
and missile launch control in weapon systems.
Do not use the XG1200 for High Safety Required Use without otherwise ensuring the safety
level required. Fujitsu and its related companies assume no liability whatsoever for damages
arising from use of the XG1200 by the user in high-safety applications, and for any claims or
compensation for damages by the user or a third party.
The XG1200 contains a class 1 laser, and can emit invisible laser light. Do not look into the
10 Gigabit Ethernet port openings. The following warning applies to the XG1200's laser:
• The XG1200 contains Xenpak modules, which are laser devices.
In the USA, these Xenpak modules are certified as Class 1 laser products that conform to
the requirements of the Department of Health and Human Services (DHHS) regulation
21 CFR Subchapter J, and this certification is indicated by a label attached to each Xen-
pak module.
Outside the USA, these Xenpak modules are certified as Class 1 laser products that con-
form to the requirements given in IEC825-1 (1993) and Amendment11 (1996) of
EN60825-1 (1994).
• Even when cables are not connected, invisible laser light may be still emitted from the
port openings. To avoid this laser light, never peer into the port openings.
Electromagnetic compatibility
Safety
Static electricity
High safety
Laser safety