Indicator leds – FUJITSU XG1200 User Manual
Page 17
16
Before Use
There are three main indicator LEDs on the front of the XG1200: Power LED, Alarm LED, and
Status LED. The following explains the LED display under various conditions.
*1: If the XG1200 is operating normally.
If a problem occurs, the front panel LEDs and the LEDs on the individual parts can be used to
identify the trouble:
*2: Only detectable and indicated when two power supply units are installed and connected to separate,
independent power supplies.
*3: Condition of the Status LED will depend on the state of the system.
Note that the XG1200 does not shut itself off when trouble is detected.
Any problems other than those that occur during start up are recorded in the event log.
For details of the event log, refer to the "User Guide".
Indicator LEDs
XG1200 Condition
LED
Power
Alarm
Status
Off
Off
Off
Off
Starting up
Power just turned on
On
On
Off
System starting up
On
Off *1
Blinking
System start-up completed
On
Off *1
On
Operable
On
Off *1
On
After shutdown
On
Off*1
Off
XG1200 Condition
LED
Power
Alarm
Status
LED on failed part
Prob
lem dete
cted
Startup error
On
Blinking
Blinking
---
Front fan error
On
On
--- *3
Front Fan LED: On
Rear fan error
On
On
--- *3
Rear Fan LED: On
Power fan error
On
On
--- *3
Power Fail LED: On
No AC supply *2
On
On
--- *3
Power Fail LED: On
Power supply error
On
On
--- *3
Power Fail LED: On
Voltage error
On
On
--- *3
---
Temperature error
On
On
--- *3
---
Xenpak error
On
On
--- *3
---
System dump in
progress
On
On
--- *3
---