Fostex VR800 - Manual (Page 91)

91
VR800 Owner’s Manual (Changing the initial setting: SETUP mode)
Modifying (or deleting) stored time signatures
1. Repeat steps 1-3 described in the “Storing a time
signature” section to display [Sign. Edit].
2. Press the HOLD/> key, the REWIND button, or the
F FWD button so that the flashing cursor is on the
time signature value.
3. Use the JOG dial to enter a new value.
Entering [—] deletes the existing data.
Note that you cannot enter [—] for measure 001.
4. Press the EXECUTE/YES key.
Caution: If modifying or deleting the stored time signature
causes the bar/beat setting for the tempo specified in the
“Setting a tempo” menu to disappear, the tempo setting will
also be automatically erased.
To cancel the setting operation, or to exit SETUP mode
after storing data, press the STOP button or the EXIT/NO
key. Each time you press one of these keys, the VR800
returns to the previous hierarchy level of the menu, and
finally exits SETUP mode.
Clearing all time signature and tempo settings
1. Repeat steps 1-3 described in the “Storing a time
signature” section to display [Sign. Edit].
2. While the measure number is flashing, turn the JOG
dial counter-clockwise to select [All Clear ?].
When [All Clear ?] appears, [SURE ?] flashes, and you can
clear the time signature and tempo data in the next step.
Caution: Using this function will erase not only the time
signature setting but also the tempo data specified in the
“Setting a tempo” menu described in the next section.
To cancel the setting operation, or to exit SETUP mode
after storing data, press the STOP button or the EXIT/
NO key. Each time you press one of these keys, the
VR800 returns to the previous hierarchy level of the
menu, and finally exits SETUP mode.
Changing the BAR at ABS “0” of the time base
1. Repeat steps 1-2 described in the “Storing a time
signature” section to display [Sign. Chk]. [2] in [-002BAR] will flash and the bar figure can be
changed with the JOG dial (Numbers that can be input
are 2~9.)
2. Turn the JOG dial counter-clockwise to select [-002
BAR OFFSET].
3. Press the EXECUTE/YES key.
4. Use the JOG dial to enter a new value.
5. Press the EXECUTE/YES key.
SETUP
DRIVE
AUTO A.PUNCH
SYNC OUT
CLK SCSI
? SURE
44.1kHz DIGITAL
CLK
SYNC OUT DRIVE
SCSI
AUTO A.PUNCH
SETUP
BAR
DIGITAL 44.1kHz
CLK
SYNC OUT DRIVE
SCSI
AUTO A.PUNCH
SETUP
BAR
DIGITAL 44.1kHz
When the JOG dial is rotated to extreme left [-002BAR
OFFSET], as shown below will appear (-002BAR is the initial
setup figure).
BAR in -002BAR/1 /00CLK, which indicates the head figure of the disk in the time base BAR/BEAT/CLK, can be changed.
Although the initial figure is -002BAR, this can be set within the range of -009BAR ~ -002BAR.
flashes
flashes
To cancel the All Clear operation, press the STOP button
or the EXIT/NO key now. Each time you press one of
these keys, the VR800 returns to the previous hierarchy
level of the menu, and finally exits SETUP mode.
3. Press the EXECUTE/YES key.
The stored time signature and tempo data in its entirety
are cleared, and the initial settings are restored.