Fostex VR800 - Manual (Page 55)

VR800 Owner’s Manual (Locate Function)
55
• You can set a preroll time in the [Preroll Time ?] menu in
SETUP mode so that the VR800 will start playback preroll
time before the locate point. You can set the preroll time
from 0 to 10 seconds. Refer to the chapter “Changing the
Initial Settings (SETUP Mode)” on page 94.
Automatic locating to the AUTO RTN START point
subsequent to playback to the AUTO RTN END point.
Note: This function is effective within 24 ABS hours. Therefore, if playback continues over the recording end point, the
VR800 will still continue counting the time. Also, when the VR800 locates ABS REC END, it will continue counting the
time from the recording end point. (However, the VR800 does not access the disk after reaching the recording end point.)
AUTO PUNCH IN point
LOCATE
PLAYBACK
LOCATE
PLAYBACK LOCATE
START
LOCATE
START
AUTO RTN END point AUTO RTN START point
STOP
PLAYBACK
LOCATE
PLAYBACK
START
Auto Play
The Auto Play function allows the VR800 to start play back automatically from the located point.
AUTO PLAY mode should be turned on before you execute the Direct Locate function described above.
1. Press the AUTO RTN/AUTO PLAY key to turn on
the [PLAY] indicator on the bottom of the display.
2. Press the LOCATE key, or memory key.
The VR800 locates the point and plays as shown in the
diagram. 3. Press the STOP button to stop the VR800.
Auto Return
This function allows the VR800 to play data up to the AUTO RTN END point, then automatically locate the AUTO
RTN START point as shown in the diagram below. To enable this function, AUTO RTN mode should be on and the
AUTO RTN START point and AUTO RTN END point should already be set.
1. Store the AUTO RTN START and AUTO RTN END
points.
Refer to the chapter “Storing a Locate Point (Edit Point)”
on page 48 for information on storing the desired points
in the AUTO RTN START key and the AUTO RTN END
key.
2. Press the AUTO RTN/AUTO PLAY key to turn on
the [RTN] indicator on the bottom of the display.
3. Start playback a little before the AUTO RTN END
point.
The VR800 operates as shown in the diagram.
• You can set a preroll time in the [Preroll Time ?] menu in
SETUP mode so that the VR800 will start playback preroll
time before the locate point. You can set the preroll time
from 0 to 10 seconds. Refer to the chapter “Changing the
Initial Settings (SETUP Mode)” on page 94.
PLAY
AUTO
RTN
AUTO
Lights up
Lights up