Tc drop, non-drop ntsc only, Tc drop, non-drop – FOCUS Enhancements DVCPRO/DV User Manual
Page 83
FS-100 Portable DTE Recorder
65
TC DROP, NON-DROP
NTSC only
These parameters are only available for NTSC and only one may
be enabled at a time. Drop and non-drop enable and disable the
drop-frame function that modifies how the timecode is calculated
during recording.
•
TC DROP
Enables the drop-frame function:
Frames 00 and 01 are dropped
from each minute of video
recorded, except for those minutes evenly divisible by ten.
•
TC NON-DROP
Group Default
Disables drop-frame. No frames are dropped during
recording and the timecode reflects the actual time during
recording.
Use with TC FREE RUN or TC REGEN
TC DROP and TC NON-DROP may only be set when using the TC FREE
RUN or TC REGEN settings.
Type of Separator Indicates TC DROP or NON-DROP
The timecode displayed on the LCD indicates the TC DROP/NON-DROP
mode by using either a semi-colon or a colon as a separator between hours,
minutes, seconds and frames:
• DROP HH
;
MM
;
SS
;
FF
• NON-DROP HH
:
MM
:
SS
:
FF