Furuno 2127 - Manual (Page 75)

4. INSTALLING OPTIONAL EQUIPMENT
4-15
4.4 Performance Monitor PM-31
This kit is installed in the antenna unit of the FAR-2107/2807 series X-band radar to monitor
radar performance.
Name: Performance monitor
Type: PM-31
Code no.: 008-080-438
Name Type Code number Qty
Ԙ SCANNER COVER ASSY. PM-31 008-539-430 1
ԙ GREASE GASKET GREASE #2
50G 000-149-704 1
Ԛ SM-XH CONNECTOR
ASSY.
03-2108 㧔6P-6P) 008-534-840 1
ԛ LIFTING FIXTURE 03-001-3264 300-132-640 1
Ԝ GASKET 03-001-3263 300-132-631 1
Procedure
To hoist the scanner cover assy. to the radar mast, by using rope, attach the lifting fixture ԛ to
the scanner cover assy. Ԙ.
1. Remove the bolt and chain at the bottom of the stern-side cover, and then remove the
cover.
2. Coat the bolt hole on the scanner cover assy.
Ԙ with silicone sealant (Adhesive 1211)
and secure the chain with the bolt.
3. Remove the cover at the bow side also.
4. Insert the XH connector of the SM-XH connector
Ԛ assy. to J911 on TB board 03P9349
and the SM connector of the SM-XH connector assy. to the relay plate.
5. Coat the gasket
Ԝ with the gasket grease #2 50G ԙ and attach it to the scanner cover
assy. Ԙ.
6. Connect the cable assembly coming from the scanner cover assy. Ԙ to the SM connector
attached at step 4 above.
7. Attach the scanner cover assy. to the stern side of the antenna unit.
8. Reattach the bow-side cover.