Furuno 2127 - Manual (Page 4)

ii
Be sure that the power supply is
compatible with the voltage rating of
the equipment.
Do not install the monitor unit,
processor unit or control unit where
they may get wet from rain or
water splash.
Fire or damage to the equipment can result
if a different cable is used.
Connection of an incorrect power supply
can cause fire or damage the equipment .
Use only the specified power cable.
Water in the units can result in fire,
electrical shock, or damage the equipment.
Attach securely protective
earth to the ship's body.
The protective earth
(grounding) is required to the
AC power supply to prevent
electrical shock.
CAUTION
Observe the following compass safe
distances to prevent deviation of a
magnetic compass:
Antenna Unit
(12 kw)
Standard
compass
2.15 m 1.40 m
Antenna Unit
(25 kw)
2.05 m 1.30 m
Monitor Unit
(MU-201CR)
1.55 m 1.00 m
Monitor Unit
(MU-231CR)
1.85 m 1.20 m
Processor
Unit (RPU-013)
1.35 m 0.85 m
Control Unit
(RCU-014)
0.30 m 0.30 m
Control Unit
(RCU-015)
0.95 m 0.60 m
Control Unit
(RCU-016)
0.65 m 0.45 m
Memory Card
Interface Unit
(CU-200)
0.90 m 0.60 m
Steering
compass
Switching Hub
(HUB-100)
1.00 m 0.60 m
Junction Box
(RJB-001)
1.10 m 0.70 m
Do not open the equipment
unless totally familiar with
electrical circuits and
service manual.
Only qualified personnel
should work inside the
equipment.
WARNING
Construct a suitable service platform
from which to install the antenna unit.
Serious injury or death can result if some-
one falls from the radar antenna mast.
Turn off the power at the mains switch-
board before beginning the installation.
Fire, electrical shock or serious injury can
result if the power is left on or is applied
while the equipment is being installed.
ELECTRICAL
SHOCK
HAZARD
Monitor Unit
(MU-190)
Monitor Unit
(MU-231)
1.65 m 1.05 m
0.85 m 0.55 m