Furuno 2127 - Manual (Page 34)

2. WIRING
2-10
Cable fabrication for the cables connected to the 03P9342 board
x Signal cable RW-9600 (Between antenna unit and processor unit)
Shield Armor
Clamp here by cable clamp.
Vinyl tape
After exposing cores,
wind shield around the armor.
Vinyl sheath
Coaxial cable
6
60 450
5
Conductor
5 9
Coaxial cable
14
Fold back shield.
x Other cables for optional units
Use TTYCS-1 or TTYCS-4 (Japan standard cable) or equivalent.
Conductor
S = 0.75 mm
φ = 1.11 mm
2
TTYCS-1
Armor
Shield
Sheath
φ =
10.1 mm
Conductor
S = 0.75 mm
φ = 1.11 mm
2
TTYCS-4
Armor
Shield
Sheath
φ = 16.3
mm
60: Peel paint.
L
5
Shield
Armor
Clamp here by cable clamp.
Vinyl tape
After exposing cores,
wind shield around the armor.
L= Depends on equipment
connected. Measure at
the processor unit.
6
Wiring for Coaxial cable
CAUTION
Clamp shied with bracket.
Tighten conductor with screw.
Procedures
1. Twist the conductor.
2. Press the terminal opener downward.
3. Insert the wire to hole.
4. Remove the terminal opener.
5. Pull the wire to confirm that it is ecure.
Terminal opener
Wiring for WAGO connector
WAGO connector
Wire
Twist
Press downward.
Do not use crimp-on lug to prevent
contact resistance from increasing.