FujiFilm FinePix A303 - Manual (Page 88)

88
AC power
adapter
✽
Camera
(USB) socket
USB
socket
PC
1. Load an xD-Picture Card containing
photographed images into your camera. Plug
the AC power adapter connector into the DC
IN 3V socket on the camera and then plug
the adapter itself into the main power outlet.
2. Slide the power switch to the side to turn
the camera on.
3. Set the “USB MODE” setting in the
“SET–UP” menu to “DSC” (
➡P.72, 73).
4. Slide the Power switch to the side to turn
the camera off.
5. Switch your PC on.
6. Use the special USB cable to connect the
camera to your computer.
7. Switch the camera on.
Always use the prescribed procedure when
disconnecting or switching off the camera
(
➡P.94).
If you are using a Windows PC, the driver settings
are specified automatically when installation is
completed. No further action is required.
✽On Windows XP and Mac OS X, you must specify the
automatic launch settings the first time you connect
the camera to your computer.
✽Take care to ensure that the special USB cable is
connected the correct way around and that the plugs
are pushed fully into the connection sockets.
7.2 Use at DSC mode
✽ Sold separately
✽It is recommended that you connect the AC Power
Adapter AC-3V (sold separately) (
➡P.87). Constant
power supply will prevent successful data transfer
from trouble caused by power supply.