FieldServer Gamewell FCI E3 Series - Manual (Page 7)

FS-8700-132 Gamewell FCI-E3 Driver Manual Page 7 of 20
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web: www.fieldserver.com
Tel: (408) 262 2299 Fax: (408) 262 2269 Toll Free: (888) 509 1970 email: [email protected]
5.2 Client Side Node Parameters
Section Title
Nodes
Column Title
Function Legal Values
Node_Name Provide name for Node
Up to 32 alphanumeric
characters
Node_ID
Only required for networked configurations. Set the
Node_ID of the local panel to zero, and create one
Node Descriptor for each panel setting the Node_ID
to the panel number.
Whole numbers 0,1,2,3 …
Protocol Specify protocol used FCI_E3
FCI_Reset_Action_Option*
Only required for networked configurations:
When not specified or set to ‘Reset_by_any_Node ‘
then the driver will reset the data array points
associated with the given node irrespective of the
reset message’s origin.
When set to ‘Reset_by_this_Node_Only’ then the
driver only resets the data associated with the given
node if the reset originated from the same node.
Reset_by_any_Node,
Reset_by_this_Node_Only
Connection
Specify which port the device is connected to the
FieldServer
P1-P8
2
Example
// Client Side Nodes
Nodes
Node_Name , Protocol , Connection
Panel-01
, FCI_E3 , P1
5.3 Client Side Map Descriptor Parameters
5.3.1 FieldServer Related Map Descriptor Parameters
Column Title Function Legal Values
Map_Descriptor_Name Name of this Map Descriptor Up to 32 alphanumeric characters
Data_Array_Name
Name of Data Array where data is to be
stored in the FieldServer One of the Data Array names from “Data
Array” section above
Data_Array_Offset Starting location in Data Array
0 to maximum specified in “Data Array”
section above
Function Function of Client Map Descriptor. Passive_Client
2 Not all ports shown are necessarily supported by the hardware. Consult the appropriate Instruction manual for details of the ports available
on specific hardware.