4 installing the tilting protection, Installing the tilting protection – FUJITSU Primecenter M1 BS2000 User Manual
Page 31
31
Setting up the PRIMECENTER Rack
Figure 5: Adjusting the PRIMECENTER M1 19-inch rack
Ê
Adjust the rack on all three axes (X,Y,Z) with the leveling feet. Use a spirit
level to make sure the rack is exactly level!
I
The horizontal orientation of the rack is required to ensure the pull-out
functions of the components mounted to the rack. The rack is set up
properly, as a rule, when the front panels of the mounted components
add up to form a continuous vertical line!
4.4
Installing the tilting protection
V
CAUTION!
●
A tilting protection is mandatory as soon as one component is
installed that can be pulled out (e. g. for maintenance reasons) via
teleskopic rails. The tilting protection prevents the rack from tipping
over.
●
The tilting protection must make firm contact with the ground at the
front.
●
Make sure that no cables were cut off when installing and moving the
tilting protection.
I
For a description to install the tilting protection for the PRIMECENTER
M1 19-inch rack please refer to the Quick Start Guide delivered with the
rack (Web: .
).