2 use at dsc mode – FujiFilm FinePix 3800 User Manual

Page 49

i When the camera and computer are exchanging

data, the self timer lamp blinks and the indicator
lamp blinks alternately green and orange.

i “DSC” appears on the screen.
i Power Save is disabled when the camera is

connected to a USB port.

✽Before replacing the xD-Picture Card, always disconnect

the camera from the PC using the procedure on P.102.

✽Do not disconnect the USB cable when the camera is

communicating with the PC. See P.102 for information
on the disconnection procedure.

Digital
(USB) socket

Camera

DC IN 5V
socket

(USB)socket

1. Load an xD-Picture Card containing

photographed images into your camera.

2. Slide the Power switch to the side to turn

the camera on.

3. Set the “USB MODE” setting in the “SET–

UP” menu to “DSC” (

➡P.80, 81).

4. Slide the Power switch to the side to turn

the camera off.

✽You should use the AC power adapter (sold

separately) the camera is connected to your PC
(

➡P.95). Loss of power during data transmission can

prevent successful data downloading.

5. Switch your PC on.
6. Use the special USB cable to connect the

camera to your computer.

7. Switch the camera on.

Always use the prescribed procedure when
disconnecting or switching off the camera
(

➡P.102).

If you are using a Windows PC, the driver settings
are specified automatically when installation is
completed. No further action is required.

✽On Windows XP and Mac OS X, you must specify the

automatic launch settings the first time you connect
the camera to your computer.

✽Take care to ensure that the special USB cable is

connected the correct way around and that the plugs
are pushed fully into the connection sockets.

7.2 Use at DSC mode

■ Camera Operation

■ PC Operation

✽ The Windows CD-ROM may also be required

during installation. In this event, switch CD-ROMs
as directed by the on-screen instructions.

i FinePixViewer automatically starts up.

Windows 98/98 SE/Me/2000 Professional

i A removable disk icon appears and you can

use your PC to transfer files to and from the
camera.

Windows

Macintosh

✽ Screen for

Windows 98 SE

If the above operations do not occur, you do not
have the required software programs or drivers
installed on your PC. Complete the required PC
setup procedures. Then reconnect the camera
to your PC.