FieldServer Optomux FS-8700-17 - Manual (Page 22)

FS-8700-17_Opto22.doc Manual Page 20 of 24
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web: www.fieldserver.com
Tel: (408) 262 2299 Fax: (408) 262 2269 Toll Free: (888) 509 1970 email: [email protected]
Read/
Write/
Both
COMMAND NAME
OPTO22_FORMAT
OPTION
MASTER
LENGTH
CONSIDERED
(See Notes)
NOTES
w SET INPUT RANGE 3
Only specified module positions have their
range set to the 2 values found in the Data
Array. 1st is high limit, second is lo limit.
r
READ OUT-OF-
RANGE LATCHES
4
High limit latches are placed in first
element of Data Array. Low limit latches
are placed in 2nd element of Data Array.
b
READ AND CLEAR
RANGE LATCHES
3
Only specified module positions get read
and cleared. Data read gets put in
corresponding positions of Data Array.
w
CLEAR OUT-OF-
RANGE LATCHES
4
r
READ LOWEST
VALUES
3
Only specified module positions get read.
Data read gets put in corresponding
positions of Data Array.
w
CLEAR LOWEST
VALUES
3
Only module positions specified get
affected by command.
b
READ AND CLEAR
LOWEST VALUES
3
Only specified module positions get read
and cleared. Data read gets put in
corresponding positions of Data Array.
r
READ PEAK
VALUES
3
Only specified module positions get read.
Data read gets put in corresponding
positions of Data Array.
w
CLEAR PEAK
VALUES
3
Only module positions specified get
affected by command.
b
READ AND CLEAR
PEAK
3
Only specified module positions get read
and cleared. Data read gets put in
corresponding positions of Data Array.
r
CALCULATE
OFFSETS
1
Only specified module positions get
calculated and read. Data read gets put in
corresponding positions of Data Array.
w SET OFFSETS 1
Only specified module positions get
written. Data written gets extracted from
corresponding positions of Data Array.
r
CALCULATE AND
SET OFFSETS
1
Only specified module positions get
calculated and read. Data read gets put in
corresponding positions of Data Array.
r
CALCULATE GAIN
COEFFICIENTS
1
Only specified module positions get
calculated and read. Data read gets put in
corresponding positions of Data Array.
w
SET GAIN
COEFFICIENTS
1
Only specified module positions get
written. Data written gets extracted from
corresponding positions of Data Array.