FieldServer Optomux FS-8700-17 - Manual (Page 19)

FS-8700-17_Opto22.doc Manual Page 17 of 24
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web: www.fieldserver.com
Tel: (408) 262 2299 Fax: (408) 262 2269 Toll Free: (888) 509 1970 email: [email protected]
Read/
Write/
Both
COMMAND NAME
OPTO22_FORMAT
OPTION
MASTER
LENGTH
CONSIDERED
(See Notes)
NOTES
w
START/STOP
COUNTERS
3
All positions are affected by command.
Non-zero (specified) module positions start
counting, zero (unspecified) module
positions stop counting
w START COUNTERS 3
Only module positions specified get
affected by command.
w STOP COUNTERS 3
Only module positions specified get
affected by command.
r READ COUNTERS 1
Data that is read is put into the
corresponding array elements of the Data
Array based on which module positions are
read.
b
READ AND CLEAR
COUNTERS
1
Data that is read is put into the
corresponding array elements of the Data
Array based on which module positions are
read.
w CLEAR COUNTERS 3
Only module positions specified get
affected by command.
w SET TIME DELAY 3
The Modifier is specified in the CSV file
with the opto22_modifier1 parameter. The
data (timeout) is retrieved from the first
element of the Data Array.
w
INITIATE SQUARE
WAVE
3
w
HIGH RESOLUTION
SQUARE WAVE
3
w
RETRIGGER TIME
DELAY
3
Only module positions specified get
affected by command.
w
GENERATE N
PULSES
3
Only specified module positions get
affected. The Modifier (byte 1&2) are
specified in the CSV file with the
opto22_modifier1/2 parameters. The data
(number of pulses) is retrieved from the
1st element of the Data Array.
w START ON PULSE 3
Only specified module positions get
affected. The data (period of pulses) is
retrieved from the 1st element of the Data
Array.
w START OFF PULSE 3
Only specified module positions get
affected. The data (period of pulses) is
retrieved from the first element of the
Data Array.