FUJITSU MAF3364LP - Manual (Page 70)

C141-E064-03EN 4 - 17
(2) SCSI connector and power supply connector
a. 16-bit SCSI
The connector for the SCSI bus is an unshielded P connector conforming to SCSI-3 type
which has two 34-pin rows spaced 1.27 mm (0.05 inch) apart. Figure 4.19 shows the SCSI
connector. See Section C.2 in Appendix C for the signal assignments on the SCSI
connector.
For details on the physical/electrical requirements of the interface signals, refer to Sections
1.3 and 1.4 in the SCSI Physical Interface Specifications.
Figure 4.19 16-bit SCSI interface connector
b. Power supply connector
Figure 4.20 shows the shape and the terminal arrangement of the output connector of DC
power supply.
Figure 4.20 Power supply connector (16-bit SCSI model)
The tolerance is ±0.127 mm (0.005 inch) unless otherwise