Furuno FAR-2157 - Manual (Page 34)

2-10
Connection of cables
The power cable is connected to the terminal board on the rear panel and the signal cable from
the monitor unit is connected to the DVI-D connector. Other cables are connected to the printed
circuit board 03P9342. Be sure to ground the unit, with IV-8sq wire (local supply).
Processor unit, rear view
*: The connector with EMI core should be connected to the processor unit.
**: The configuration of optional cable between the processor unit and the control unit is as follows.
Note that the cable fabrication for each end is different.
Cable XH10P-W-6P L=20/30M
When the RCU-016 is installed, optional cable (XH10P-W-5P-A, L=10/20/30M) is required. Cable
fabrication for each end is the same.
Cable XH10P-W-5P-A L=10/20/30M
F1
1
2
ACK φ18.9
AIS
1 7
AD100
8
GYRO
28
PSU004
24 φ7.4 VDR IN φ7 VDR OUT
24' 26
9 14 17
15
DC/AC
21
φ9 HDG
3 2 5 4 6
RSD
19 18 20
Monitor unit
Network DVI-D monitor
Cable clamp for power cable
Terminal board for power cable
Remove the
protective cover.
Control unit
**
Heading senor
Speed log
Navigator
Memory Card IF unit
VDR OUT
VDR IN
Gyrocompass
AD-100
AIS
Antenna unit Cable clamp
GND TERMINAL
Power cable
*
Power supply unit
FUSE
F70
Control unit
Processor unit
10/20*/30* m
300 mm 150 mm
*: Option
160 mm
350 mm
10/20/30 m
150 mm 150 mm
Control unit
Processor unit