Furuno FAR-2157 - Manual (Page 23)

1-15
1.4 Processor Unit
Mounting considerations
When selecting a mounting location, keep in mind the following points:
• Locate the processor unit away from heat sources because of heat that can build up inside the
cabinet.
• Locate the unit away from places subject to water splash and rain.
• Leave sufficient space at the sides and rear of the unit to facilitate maintenance, referring to the
outline drawing.
• A magnetic compass will be affected if the processor unit is placed too close to it. Observe the
compass safe distances on page ii to prevent interference to a magnetic compass.
Mounting procedure
Fix the unit with four M6 bolts or self-tapping screws.
Mounting dimensions for processor unit
25
340±1
380
385
410
350±1
2- φ7 FIXING HOLES
R3.5
370±1
7
2-FIXING NOTCH
#50
# Minimum recommended
service space
Do not unfasten
this screw.
Upper case assy.
Lower case assy.
Note: If you fix the unit with the
cable entry up, do not unfasten
the screw (M3x10) that fastens
the upper case assy. and lower
case assy. of the processor unit.