FUJITSU MAW3073NC/NP - Manual (Page 91)

C141-E226 5-19
5.6.4 Setting parameters
The user can specify the optimal operation mode for the user system environments by setting the
following parameters with the MODE SELECT or MODE SELECT EXTENDED command:
• Error recovery parameter
• Disconnection/reconnection parameter
• Caching parameter
• Control mode parameter
With the MODE SELECT or MODE SELECT EXTENDED command, specify 1 for the "SP" bit
on CDB to save the specified parameter value on the disk. This enables the HDD to operate by
using the parameter value set by the user when power is turned on again. When the system has
more than one initiator, different parameter value can be set for each initiator.
When the parameters are not set or saved with the MODE SELECT or MODE SELECT
EXTENDED command, the HDD sets the default values for parameters and operates when power
is turned on or after reset. Although the HDD operations are assured with the default values, the
operations are not always optimal for the system. To obtain the best performance, set the
parameters in consideration of the system requirements specific to the user.
This section outlines the parameter setting procedures. Refer to Subsection 3.1.5 "MODE
SELECT (15) " and 3.1.6 "MODE SELECT EXTENDED (55) "of the SCSI Logical Interface
Specifications for further details of the MODE SELECT and MODE SELECT EXTENDED
commands and specifying the parameters.
IMPORTANT
1. At factory shipment of the HDD, the saving operation for the MODE
SELECT parameter is not executed. So, if the user does not set
parameters, the HDD operates according to the default value of each
parameter
2.
The MODE SELECT parameter is not saved for each SCSI ID of but as
the common parameter for all IDs. In the multi-initiator System,
parameter setting cannot be changed for each initiator.
3.
Once parameters are saved, the saved value is effective as long as next
saving operation is executed from the initiator. For example, even if the
initialization of the disk is performed by the FORMAT UNIT command,
the saved value of parameters described in this section is not affected.
4. When the HDD, to which the saving operation has been executed on a
system, is connected to another system, the user must pay attention to
that the HDD operates according to the saved parameter value if the
saving operation is not executed at installation.