Furuno FM-8700 - Manual (Page 22)

19
System < Own-ID number >
V P ID DSC RT CH PO
Figure 14
6. Enter ship's ID (nine digits). To correct the data entered, press the
CANCEL key and reenter ID number.
7. Press the ENT key.
Setting up DSC Block
When two FM-8700s are installed, designate one as Main (CH70)
and the other as Sub (VHF). The default setting is “CH70” as main
unit. For sub unit, do the following.
Procedure
1. Rotate the VOLUME knob on the sub FM-8700 clockwise to
turn it on.
2. Press the SELECT and 9 keys to display the System menu.
3. Press right arrow key to select DSC.
4. Press the ENT key.
DSC:receiver < CH70 >
CH70 [1] VHF[2]
Figure 15
5. Press the 2 key to select VHF[2].
6. Press the ENT key. The display changes to the System menu.
Setting up the VHF Block
Procedure
Highlighted items in this section are default settings.
1. Press right arrow key to select RT at the System menu.
2. Press the ENT key.
RT 1-Mode:USA/WX< OFF >
OFF [1] ON[2]
Figure 16