Furuno FM-8700 - Manual (Page 16)

13
Figure 6 How to attach the M-type plug to the coaxial cable
Connection of CH70 Rx Antenna
The CH70 Rx antenna is connected to the duplexer unit with a 50
ohm coaxial cable, type 5D-2V. Attach an M-type plug to the cable
(if necessary) as shown in Figure 6. Screw the plug into the CH70
ANT connector at the buttom of the duplexer unit.
Connection of Handset
Connect the handset cable to the HANDSET port on the rear of the
tranceiver unit.
Grounding the Transceiver Unit
Fasten a ground wire (local supply) between the GND terminal at the
rear of the transceiver unit and ship’s hull (or ground bus).
CAUTION
Ground the equipment to
prevent electrical shock
and mutual interference.