FUJITSU fi-4750L - Manual (Page 71)

7-3
No. Item Description
Selectable
parameters
Default
10 IPC status display
The type of IPC option (IPC-4D) is
displayed.
11 SCSI ID setting The SCSI ID is selectable.
SCSI ID:
0/1/2/3/4/5/6/7
5
12
SCSI terminator
setting
Switch the SCSI terminator On/Off. On/Off On
13
Low Power Mode
setting
Change the default setting of the duration
for power save.
5 min.
to 60 min.
15 min.
14 Select Interface
Select the interface when the scanner has
a board in the third party Slot.
Auto/SCSI/Tps Auto
15
Display TPS Board
ID Number Display the ID number of the board in the
third party Slot.
16 IPC mode
When the IPC-4D image processing board
is installed in the third party slot, select this
IPC-4D board or the image processing
circuit built in the scanner.
Standard/IPC4D Standard
17 ADF Edge Erasing
Adjusts the edge areas to be erased from
the image scanned by the automatic
document feeder (ADF).
Left/Right:
0 to 15 mm
Top:
0 to 15 mm
Bottom:
-7 to +7 mm
Left/Right:
0 mm
Top:
0 mm
Bottom:
0 mm
18 FB Edge Erasing
Adjusts the edge areas to be erased from
the image scanned by the flat bed (FB).
Left/Right:
0 to 15 mm
Top:
0 to 15 mm
Bottom:
0 to 15 mm
Left/Right:
0 mm
Top:
0 mm
Bottom:
0 mm
(Continued)
* This offset refers to the difference from the value adjusted by automatic offset adjustment.
** Some restrictions apply to the detection of a double feed.