FUJITSU fi-4750L - Manual (Page 37)

3-3
Manual Feed Mode Setting
In this mode, the scanner waits for some predetermined time before issuing a “Paper Empty” message
after all documents are read. This predetermined time (time-out limit) is specified in the Setup mode.
Therefore, you can set the next documents on the ADF chute without interrupting the reading opera-
tion. The procedures for setting the manual feed mode are as follows:
1 Turn the power On and verify that
“Scanner Ready” is displayed on the
LCD.
2 Press then the scanner displays
Screen M2.
NOTICE
The “Mode Select 0” screen is skipped when
your scanner is controlled through the SCSI
interface.
3 Press then the scanner displays
Screen M3.
4 Press then the scanner displays
Screen M4.
5 Select “Yes” by pressing . Then press .
6 Press to return to the “Scanner
Ready” screen. Note that “Manual Feed”
is shown on the LCD. This means that the
scanner is in Manual Feed mode.