Fluke Data Acquisition System/Data Logging System 2680A - Manual (Page 28)

2680A/2686A
Getting Started Guide
18
Host Computer and Network Preparation
This section contains information for preparing your host computer and setting up
network communication, as summarized below.
Installing Host Computer Ethernet Adapter
Skip this section if you have an Ethernet adapter installed on your computer.
Since the installation procedures for Ethernet adapters change frequently and
without notice, you must follow the instructions supplied with your particular
Ethernet adapter. If your host computer is already on a network, it probably has an
Ethernet adapter already installed.
To install an Ethernet adapter, use the following procedure:
1. Close all applications. Exit Windows and turn the host computer off.
2. Follow the installation instructions in the manual supplied with your Ethernet
adapter to install the hardware. Do not install driver software at this point.