FUJITSU fi-4860C - Manual (Page 69)

AP-8
■ Alarm message (Hardware error
:Check LED lighting
)
The following messages are displayed, when an error occurs inside the sccaner. In this
case, please switch on the power supply once again after disconnecting the power
supply.
If the same message is displayed again, please contact to a distributor or an nearest
imaging service and support center for help.
(Front side) The following message is displayed, when an error occurs to the
front side optical unit.
(Back side) The following message is displayed, when an error occur to the
back side optical unit.
(Toransport motor) The following messages are displayed, when the fuse of various
motors (Toransport motor, Separation motor, Pick motor, Hop-
per motor) goes out.
(Separation motor)
(Pick motor)
(Hopper motor)
p c a i O t l A l r m a
F o r n d e i t S
p c a i O t l A l r m a
B c a k d e i S
F d e e m o t r o
F s u e a l r m a
p S a r e a i o t n
F s u e a l r m a
m o t r o
P k c i m o t r o
F s u e a l r m a
m o t r o
F s u e a l r m a
H p r e o p