beautypg.com

Important – Fisher & Paykel DS602I User Manual

Page 4

background image

Page DS_03

Where the DishDrawer is

in an under counter

situation, i.e. built into a

kitchen unit, it is

recommended that bare

wood surrounding the

DishDrawer is sealed with

an oil based paint or

polyurethane to prevent

possible steam damage.

IMPORTANT

IMPORTANT

STEP 1.3 OPTIONS FOR INSTALLING MULTIPLE PRODUCTS

IMPORTANT

IMPORTANT

IMPORTANT

If mounting the

DishDrawer near the

bottom of the cabinet,

ensure there is adequate

room underneath the

supporting cabinet to

tighten bolts.

Ensure the cavity sides are

plumb (vertical) as this will

assist with leveling the

DishDrawer.

Ensure the Services Hole is

as close as possible to the

rear corner of the cabinet.

The hole can be located

on either side depending

on the location of the

services.

On corner installations

ensure that there is a gap

of 2" (50mm) minimum

between the adjacent

cabinetry and sides of

drawers.

STEP 1.4 ELECTRICAL, PLUMBING & DRAINAGE INFORMATION

ELECTRICAL

GROUNDING INSTRUCTIONS

PLUMBING - WATER SUPPLY

a)

The water connection is to be made to a hot water supply only. Ensure the water

temperature is not greater than 140°F (60°C).

b)

A readily accessible shut off valve must be installed in the supply pipe.

c)

The water supply pressure is to be between 4.3 p.s.i. minimum and

139 p.s.i. maximum.

d)

The inlet supply hose must be connected to the water supply using a

3

/

8

"

compression type water supply fitting.

e)

Ensure sealing washer supplied with connection hose is fitted.

This appliance must be grounded. In the event of malfunction or breakdown,

grounding will reduce the risk of electric shock by providing a path of least

resistance for electric current.

This appliance is equipped with a cord having an equipment-grounding conductor and a

grounding plug. The plug must be plugged into an appropriate outlet that is installed and
grounded in accordance with all local Codes & Ordinances.

Care should be exercised when the appliance is installed or removed, to

reduce the likelihood of damage to the power supply cord.

If the power supply cord is damaged, it must be replaced by the Manufacturer, it’s Service

Agent or a similarly qualified person, in order to avoid a hazard.

The power supply receptacle for the appliance should be installed in a cabinet or on a wall

adjacent to the under counter space in which the appliance is to be installed.

The power supply receptacle should be positioned between 6" and 18" (150mm and

450mm) from the cabinet opening of the DishDrawer.