Fisher & Paykel DS602I - Manual (Page 10)

STEP 2.3 FLEXIBLE EXTRUSION ATTACHMENT FOR
24” (610mm) CAVITY
Wiring, Plumbing and
Services should be
completed before
attaching the flexible
extrusion.
TIP
2.3.1
Flexible Extrusions are supplied to enable
the installer to help fill any excess space
between the sides of the DishDrawer and
the cavity. The two lengths of Flexible
Extrusion (supplied) should be attached
before pushing the DishDrawer into the
cavity for final installation. This Extrusion
is designed to fit a 24” (610mm) width
cavity.
2.3.2
Open the drawers, exposing the chassis
trim.
2.3.3
Remove backing from adhesive tape on
Flexible Extrusion.
2.3.4
Apply as per drawings, ensuring the
curved edge of the Flexible Extrusion
fits around the corner of the chassis trim.
2.3.5
When checking final fit, ensure
DishDrawer is centered and there are even
tolerances between DishDrawer and
cavity.
Page DS_09