Fisher & Paykel DS602I - Manual (Page 20)

SECTION 12 FINAL CHECKS
STEP 7.1 INSTALLATION WET TEST
SECTION 7
STEP 7.2 TROUBLESHOOTING
Water underneath DishDrawer, check the hose connections
and hose for leaks.
Water around water supply and drainage connections - check
connections, existing plumbing and hoses for leaks.
Excessive water remaining above the filter plate, after the rinse cycle,
check for kinked drain hoses or blocked waste connection.
No water supply, check water is on and there is water pressure.
If a fault occurs, consult the Problem Solver Section of the
Use & Care Manual.
If unable to resolve, contact Customer Care Center.
Ensure Power is connected and is switched ON.
Ensure the water supply is connected and ON.
LEAVE ALL LITERATURE WITH THE CUSTOMER.
1.
2.
3.
5.
4.
6.
Ensure product is level, securely fastened to the floor and opens
and closes freely.
Ensure inlet hose to faucet connection is tightened to specification.
Ensure any knockouts or plugs in the drain connection have been
drilled out and the drain connection made correctly.
Plug in and turn ON the power and water supply. The DishDrawer
should "beep" and light up.
Open the drawers of the DishDrawer and check operation of
Secondary Control Panel and check sprayarm is in place and
free to rotate.
Select Rinse program on the Secondary Control Panel and close the
drawer.
Start the Program by pressing the Start/Pause button.
After the program has finished, check underneath the DishDrawer
for water leakage. Ensure machine has run and drained correctly.
Check water supply and drainage connection for leakage.
1.
2.
3.
4.
5.
6.
7.
8.
9.
Page DS_19