Forno 30 Inch Single Electric Wall Oven Installation Guide - Manual (Page 12)

11
STEP 4 - MAKE ELECTRICAL CONNECTION
To properly install your oven, you must determine the type of electrical connection
you will be using and follow the instructions provided for it here.
DIRECT WIRE
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Improper connection of aluminum house wiring and copper appliance
leads can result in an electrical hazard or fire. If the home has aluminum
wiring, only use connectors designed and UL listed for joining copper to
aluminum and precisely follow the manufacturer's recommended
procedure. Aluminum-to-Copper connections must conform with local
codes.
For Single Oven, use 10 gauge copper or aluminum wire.
For Double Oven, use 8 gauge copper or aluminum wire.
Electrically ground oven.
Failure to do so can result in death, fire or electrical shock.
Be sure your appliance is properly installed and grounded by a qualified
technician. Ask your dealer to recommend a qualified technician or an authorized
repair service.
This oven is manufactured with a neutral (white) power supply wire and a cabinet-
connected green (or bare) ground wire twisted together.
After making sure that the power has been turned off, connect the flexible conduit
from the oven to the junction box using a UL listed conduit connector. The
Grounded Neutral and Ungrounded Neutral Graphics on the following pages and the
instructions provided, present the most common way of connecting ovens. Your
local codes and ordinances, of course, take precedence over these instructions.
Complete electrical connections according to local codes and ordinances.
1. Disconnect power.
2. Remove junction box cover.
3. Install a UL listed or CSA approved conduit connector to the junction box.
a
a
UL or CSA Listed Conduit Connector