KORG ARP 2600 M Analog Synthesizer Module with Carrying Case - Manual (Page 9)

- 9 -
Owner
’s manual
Front panel (VCO-3 section)
a
b
d
c
l
m
h
i
j
k
e f g
VCO-3 (Voltage Controlled Oscilator 3)
a . INITIAL OSCILLATOR FREQUENCY slider . . . . . . . . . . . . . . . . . . .[10( .03)Hz…10K(30 .)Hz]
Broadly adjusts the VCO-3 pitch.
The frequency range is an approximate value.
b . FINE TUNE slider
Finely adjusts the VCO-3 pitch.
c . PULSE WIDTH slider . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [10%…90%]
Adjusts the duty cycle of the VCO-3 pulse wave.
d . CV input 1 jack
This is the pitch CV input jack for VCO-3. The KBD CV is internally connected.
e . CV input 2 jack
This is the pitch CV input jack for VCO-3. The noise generator is internally
connected.
f . CV input 3 jack
This is the pitch CV input jack for VCO-3. The ADSR is internally connected.
g . CV input 4 jack
This is the pitch CV input jack for VCO-3. The sine wave of VCO-2 is internally
connected.
h . AUDIO/LF select switch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [KBD ON, KBD OFF]
Selects whether to use VCO-3 as an audio signal or as an LFO. When using
VCO-3 as an LFO (KBD OFF), the KBD CV will no longer be input into VCO-3.
i . CV input 2 level slider
Adjusts the signal level of VCO-3 CV input 2.
j . CV input 3 level slider
Adjusts the signal level of VCO-3 CV input 3.
k . CV input 4 level slider
Adjusts the signal level of VCO-3 CV input 4.
l . SAWTOOTH output jack
Outputs the sawtooth wave of VCO-3.
m . PULSE output jack
Outputs the pulse wave of VCO-3.