KORG ARP 2600 M Analog Synthesizer Module with Carrying Case - Manual (Page 20)

ARP 2600 M
- 20 -
Let’s make some sounds
Basic settings
Set the ARP 2600 M’s controls (sliders, switches, etc.) as shown in the illustration
below.
When you play the keyboard with these settings, the sound of the VCO-1 square
wave is output by itself. To adjust the volume, use the MIXER section’s input level 2
slider (see “MIXER” on page 13).
Tuning
After you set this unit to the basic settings
described previously, adjust the FINE TUNE
slider of each VCO to the correct pitch using a
commercially available tuner (such as the Korg
CA-50).