VARI-LITE VL6000 Beam User Manual
Page 93

T
ROUBLESHOOTING
AND
M
AINTENANCE
A
02.9708.0002
27 April 2017
75
Step 3. At rotating gobo wheel, slowly rotate wheel by hand until gobo to be removed is visible on
assembly.
Step 4. Carefully remove spring. Use pliers to help lift spring if necessary. Remove gobo glass.
Figure A-5: Rotating Gobo Wheel - Gobo Installation
Step 5. To install new gobo:
a. Align flat of glass to flat in carrier.
b. Replace spring. Ends of spring should be on carrier flat. Confirm that all corners of
spring are secured in groove.
Open Position
(no gobo)
Note
:
Assembly shown for clarity.
Front of Assembly Shown
(side towards front lens)
Rotating Gobo
Wheel Assembly
CAUTION:
Do not touch glass with bare fingers.
Handle by gobo carrier only.
Gobo Glass
Spring