Photogenic Professional Lighting Matrix MCD400R Monolight with Ion Inverter, Beauty Dish, Grid, and Stand - Manual (Page 9)

P a g e 9 | 16
a. To use group function, you need the optional MCD-TXC remote control. When the studio
flashes are on the same channel and group as the MCD-TXC remote control, the flash output
and modeling lamp can be remotely controlled (Fig. 13).
b.
There are 4 different groups from Ga, Gb, Gc to Gd. Press UP/DOWN button to set flash into
the different groups (Fig. 14A & 14B).
Press SLAVE once
c. When the Matrix studio flash is at page “Fx ”, press SLAVE button once to enter into radio group
setup page “Gx” (Fig.15A & 15B).
d. The following table shows how to set the same groups between the matrix light and remote
controller.
Figure 14A Figure 14B
Figure 15A Figure 15B