Irritrol Climate Logic User Manual

Page 3

Quick Start Setup Guide

Quick-Start Guide

Step 6 – Press and hold the sensor Test Pin for 10–15

seconds to activate the Weather Sensor!

A red LED (viewable through the lower vent

ring) will illuminate twice after 10 seconds to

confirm activation (if not already active).

See page 9.

Step 7 – Press the sensor Test Pin again to confirm

signal reception at the Receiver Module. The

receiver’s red LED will turn on momentarily

when the signal is received. Press the

BYPASS

key to cancel the Dry-out mode delay period

and resume normal operation. See page 9.

Note: If the LED does not turn on, refer to the

Weather Sensor setup procedure on page 19.

Step 8 – Check the Rain Sensor threshold setting and

adjust as needed. See page 10.

Step 9 – Secure the Weather Sensor to a rain gutter

or other suitable structure that provides

unrestricted exposure. Adjust the sensor

alignment to vertical. See page 11.

CLIMATE LOGIC

40%

Dry Out Remain 12h

10:15

BYPASS

11/16

CL User Guide Final Edit.indd 3

2/11/11 5:19 PM