Reset to factory defaults, Water adjust, Erase all? all data will be lost – Irritrol Climate Logic User Manual
Page 15: Water adjust feature
Utility Menu Options / Water Adjust Feature
15
Default (
DEFAULT _ ENTER
): The Default utility feature enables
all user-defined setup parameters to be either erased and reset to
the factory default settings, or a complete system reset includ-
ing Location, History, and Sensor Pairing.*
• Press the
YES
key to reset to the Factory Default settings.
See Default settings listed on page 12.
• Press the
NO
key to return to the previous screen.
• Press the
ERASE
key to display the Erase All prompt screen.
• Press the
NO
key to return to the Utility Menu screen.
• Press the
FACTORY
key to return the Factory Reset screen.
• *Press the
YES
key to initiate the complete system reset.
Complete the procedure as indicated on the prompt screens.
Water Adjust Feature
The Water Adjust feature enables watering time to be fine-tuned
by applying small adjustments universally to all weather-regulated
stations.
From the Home screen, press the
or
key to access the
Water Adjust screen and to adjust scale. Press the
SAVE
key
to enter the change and return to the Home screen.
Note: If a particular watering zone appears over-or under-watered,
adjust the station run time in the controller watering program.
It is considered best practice to make adjustments in small increments;
allowing several days between changes to observe the results.
Reset To
Factory Defaults?
YES
NO
ERASE
WATER ADJUST
MORE
LESS
SAVE
CANCEL
Erase All?
All data will be lost!
YES
NO
FACTORY
CL User Guide Final Edit.indd 15
2/11/11 5:19 PM