Irritrol Climate Logic - Manual (Page 2)

2
Topic
Climate Logic System Quick-Start Guide
The Quick-Start guide provides the essential steps required to properly install and setup the
Climate Logic system in the most direct route possible. As needed, refer to the detailed information
on the page number listed with each step.
Step 1 – Connect and secure the Receiver Module next
to the controller. See page 6.
Step 2 – Adjust controller program A for the hottest/
driest conditions expected, without causing
over-watering and runoff. Retain all watering
time/day restrictions in the program schedule
as required See page 6.
Step 3 – Synchronize the Receiver Module and controller
to the current time and date. See page 7.
Step 4 – Insert the Receiver Module Setup Card as
shown. See page 8.
Step 5 – Establish your location by entering the five-digit
ZIP code, or Lat/Lon coordinates as preferred.
See page 8.
2
Quick Start Setup Guide
EARTH GROUND
MV/ Pump Sensor
+ -
7 8 9 10 11 12
1 2 3 4 5 6
24 VAC VC
MENU
_ _ _ F 100%
CLIMATE LOGIC
9:15 a 11/16
THIS SIDE UP THIS SIDE UP
CLIMATE LOGIC
MENU
1:15 a 11/16
69 F 30%
CLIMATE LOGIC
SETUP CARD CLIMATE LOGIC
SETUP CARD TM
CLIMATE LOGIC
MENU SET LOC
No Rain - Irrigation
MUST SET LOCATION
F
40%
– – –
CLIMATE LOGIC
SETUP CARD CLIMATE LOGIC
SETUP CARD
THIS SIDE UP
CLIMATE LOGIC CLIMATE LOGIC CLIMATE LOGIC
TM TM
Location
LAT
LONG
North America
-000.0000
00.0000
SAVE CANCEL ZIP NEXT
Location
ZIP
00000
SAVE CANCEL LAT NEXT
CL User Guide Final Edit.indd 2 2/11/11 5:19 PM