Weather sensor battery replacement – Irritrol Climate Logic User Manual
Page 20

20
Weather Sensor Battery Replacement
Weather Sensor Battery Replacement
In normal operating conditions, the Weather Sensor’s single, 9V-Alakaline battery can provide service up
to five years. A loss of signal will result from a weak battery condition. Replace the battery as follows:
• The battery is stored in the upper half of the
sensor housing. To access the battery, release
and remove the upper housing by twisting it
clockwise while holding the base stationary.
• Disconnect the battery wire clip. Remove the
used battery and insert a fresh 9V-Alkaline
battery between the foam pad and housing.
Reconnect the battery wire clip.
• To reassemble the sensor housing, dress the
antenna wire through the lower housing,
exiting the center hole in the bottom grid.
• Mate the halves squarely, aligning the trans-
lucent dome above the mounting bracket.
• Turn the upper housing counterclockwise
to lock into lower housing (held stationary).
Note: Proper disposal of all batteries is very im-
portant for the environment and must comply
with the battery manufacturer’s recommended
procedures.
9V
9V
REMOV
E
CL User Guide Final Edit.indd 20
2/11/11 5:19 PM