MK Products CobraMig 260 PS/Feeder - Manual (Page 8)

CobraMig 260 Owner's Manual - Page 2
WARNING
A fused line disconnect switch should be installed in the
input circuit to the welding machine. This would ensure a complete
removal of all electrical power when performing service.
Before connecting input power cord verify input power requirements by
checking data plate on rear of unit. Do not connect if your input power voltage
is different from the voltage indicated on the input specifi cation panel.
Turn off all power at the disconnect.
Remove the right lower panel, as viewed from front, and locate power block
at rear of unit.
Determine input Voltage and MOVE both Voltage Links to match INPUT
VOLTAGE on BOTH Terminal blocks "TB1" and "TB2", these need to be set
the same or damage WILL occur to the unit.
- - - IMPORTANT - - -
This unit has low and high power terminal blocks (TB1 & TB2)
that must have the SAME jumper confi guration.
Put BOTH Voltage Links to same terminal block screws.
SEE SAMPLE HOOK UP DIAGRAM BELOW
FOR EXAMPLE OF VOLTAGE LINK PLACEMENT.
Voltage Link