MK Products CobraMig 260 PS/Feeder - Manual (Page 22)

CobraMig 260 Owner's Manual - Page 16
Section C Accessories
Optional Kits
Remote Voltage Kit ...........................................................................005-0584
Enables the power supply to be controlled from 25' pendant.
LCD Meter Kit ...................................................................................005-0354
Digital Volt and AMp meters with memory feature to hold and
alternately display volts and amps for 1 minute after welding.
Timer Kit ...........................................................................................005-0586
Add on panel includes spot timer and stitch weld option.
Torch Hanger Kit ...............................................................................005-0169
Allows you to hang torch on side of power supply.
Easilly hooks on and off.
Gas Control/Trigger Latch Kit ...........................................................005-0674
Adds Pre/Post Purge and Trigger function options.
Water Flow Kit ..................................................................................005-0253
Monitors water pressure in torch. No water - no arc.
Section D Maintenance
Routine Maintenance
Maintenance of the torch will normally consist of a general cleaning of
the wire guide system, including tubes, drive rolls, and conduits at regular
intervals.
Remove spatter build-up from inside of nozzles with a hardwood stick.
The only parts on the Cobramatic system that are subject to normal wear are
the conduit, contact tips, gas cups, front body liners, wire guides, drive and
idler rolls. A supply of these parts should be maintained on hand.
Power Supply
Periodically inspect all cables and hoses for damage or breaks in the
insulation jacket, particularly at the plugs or ends. Repair or replace cables
or hoses as necessary.
Remove grease and dirt from components and remove moisture from
electrical parts and cables.
Be sure that all connections are clean and tight.
WARNING:
ELECTRIC SHOCK can kill.
Shut-off disconnect and unplug unit before cleaning unit.
Every six months blow out or vacuum dust and dirt from the internal
components of the power supply. Remove the side panels and use a clean,
dry air stream or vacuum suction for the cleaning operation. If repairs do
become necessary, any part can easily be replaced by a qualifi ed shop
maintenance man.
Your CobraMig 260 is designed to provide years of reliable service. Normal
wear and component failure may require occasional service. The number of
units in operation and the importance of minimal “down time” will determine to
what extent spare parts should be stocked on hand.