Microsens MS453522M User Manual
Page 15
MICROSENS 8 Port Gigabit Ethernet Switch
User’s Manual
10
•
TP Port and Cable Installation
⇒ In the switch, TP port supports MDI/MDI-X auto-crossover, so both types of cable, straight-
through (Cable pin-outs for RJ-45 jack 1, 2, 3, 6 to 1, 2, 3, 6 in 10/100M TP; 1, 2, 3, 4, 5, 6, 7, 8
to 1, 2, 3, 4, 5, 6, 7, 8 in Gigabit TP) and crossed-over (Cable pin-outs for RJ-45 jack 1, 2, 3, 6
to 3, 6, 1, 2) can be used. It means you do not have to tell from them, just plug it.
⇒ Use Cat. 5 grade RJ-45 TP cable to connect to a TP port of the switch and the other end is
connected to a network-aware device such as a workstation or a server.
⇒ Repeat the above steps, as needed, for each RJ-45 port to be connected to a Gigabit
10/100/1000 TP device.
Now, you can start having the switch in operation.
• Power On
The switch supports 100-240 VAC, 50-60 Hz power supply. The power supply will
automatically convert the local AC power source to DC power. It does not matter whether any
connection plugged into the switch or not when power on, even modules as well. After the
power is on, all LED indicators will light up immediately and then all off except the power LED
still keeps on. This represents a reset of the system.
• Firmware Loading
After resetting, the bootloader will load the firmware into the memory. It will take about
30 seconds, after that, the switch will flash all the LED once and automatically performs self-test
and is in ready state.